(1) She's plated in the bows with steel eighteen mil thick

(2) Sony was responsible for the increase in star salaries when they coughed up $20 mil for Jim Carrey to play The Cable Guy.

(3) She gets the quarter of a mil if she goes quietly into that gentle night.

(4) Jeter signed a 10-year contract worth $18.9 million annually, so that $18.9 mil figure would be included in the MLBPA's calculations.

(5) The Big Brother housemates have almost squandered a quarter of a mil through sheer stupidity.

(6) Use barriers made of flexible polyethylene 30 to 40 millimeters thick (60 mil for very aggressive types) and 22 to 28 inches deep.

(7) The insurance company coughed up five mil

(8) The quarter mil is thought to be the largest ever fine by a team against one of its players, though we bet it will be drastically reduced sometime soon.

(9) To varying degrees the Marlins, Dodgers, Mets, and Orioles chased him, but it was the Angels who came away with the prize, signing Guerrero for five years and $70 million, an average of $14 mil per year.

(10) He already has cashed a $6.5 mil bonus check, and he is scheduled to make $24.5 mil over the next five years (which will seem like 10 to a Lions fan).

(11) The insurance company coughed up five mil

(12) Research has indicated that the optimum thickness for the total paint coat (primer and two top coats) is 4-5 mils or about the thickness of a sheet of newspaper.

(13) The drops have to be small enough to hang in the air instead of immediately falling to the slab surface, which puts them in the range of about 5 mils or smaller.

(14) PCI design guides recommend routing signal lines along a similar path with trace lengths matching to within 25 mils .

(15) With a typical pop/rock record, the groove will be 2.5 mils (thousands of an inch) wide, and will move from side to side a total of 2.5 mils .

(16) Both are sold in grades by thickness, measured in mils (one-thousandth of an inch).

(17) Rousos adds that a buildup of 40 to 60 mils is very important.

(18) Third, layout engineers also need to ensure trace lengths between lanes match to within 15 mils .

(19) It is graduated every mil and numbered every 5 mils .

(20) Tape thickness is approximately 1.5 mils and tape path component tolerances are in the 0.0004-inch range.

(21) Currently the American Concrete Institute's ‘Guide for Concrete Floor and Slab Construction’ recommends that the thickness of the vapor retarder be not less than 10 mils .

(22) Many have observed the benefit of using materials with a minimum thickness of 15 mils when ready-mix trucks or laser screeds drive directly on the vapor retarder.

(23) Some sheet metal, particularly that used in the manufacture of steel studs and other steel-framing members, may also be referred to by its thickness in mils .

(24) Conventional spray and dip coatings go on in microns and mils .

(25) One coat of some paints will measure between 10 and 14 mils , says Rafie.

(26) This gave us 215 mils of waterproofing protection on all of the vertical walls.

(27) The average thickness of FPO in Europe is about 60 mils, and no product sold there is less than 48 mils .

(28) Another trend with EPDM has been to upgrade membrane thickness from 45 mils - the ASTM minimum - to 60 and 90 mils .

(29) TPOs are available in white, light gray, and black with thicknesses of either 45 mils or 60 mils .